L3Harris XL Series Operator's Manual page 120

14221-1850-2000, Rev. C
A.5 PUT THE RADIO IN WI-FI PROGRAMMING MODE
NOTE
To put the radio in Wi-Fi programming mode:
1. Press and hold the menu button while powering on the radio.
2. The WIFI INSTALL ACTIVE screen appears on the radio.
3. Initially, the radio displays DISCONNECTED. When the IP address is displayed, the radio is
available to be programmed.
NOTE
A.6 DISCOVERY AND PROGRAMMING IN THE RPM2 APPLICATION
1. Start RPM2.
2. Disconnect the radio from the programming cable.
3. Select the Radio tab
4. When the Wi-Fi connection button is pressed, a "Discovering Wi-Fi Radios" message is
displayed for several seconds and the radios connected to that access point with that Service
Name populate the connection list.
To connect over Wi-Fi, the currently active personality MUST have the correct Wi-Fi
parameters. Therefore, care must be taken that all personalities on a given radio
have the correct Wi-Fi parameters for the desired network. Otherwise, activation of
another personality on the radio will result in the inability to establish a Wi-Fi
NOTE
connection.
5. Select a radio or radios and perform the desired action. Only Read Personality, Write
Personality, and Load Code are supported over Wi-Fi. See the table below for the supported
combinations.
120
When using multiple Control Heads, only power on the Control head that is being
put into Wi-Fi mode. All other control Heads must remain powered off for the
duration of Wi-Fi programming. Upon returning to operational mode and powering
up the remaining control heads, they will be updated.
Figure 11-5: Enable Wi-Fi Programming Mode on Radio
Refer to Section 5.23 for Wi-Fi Client selection information.
and click the Wi-Fi connection button .