Programmable Buttons; Table 6-2: Programmable Button Options - L3Harris XL Series Operator's Manual

14221-1850-2000, Rev. C
6.6

PROGRAMMABLE BUTTONS

NOTE
Press the down navigation button while on the main display to view the functions assigned to the
programmable buttons. The programmable buttons are programmed using RPM2. A delay of 0 to
10 seconds can be defined using RPM2 for the programmable buttons. Refer to Figure 4-1 and
Figure 4-2 for the location of the programmable buttons on the XL Control Head and KMM. Table
6-2 lists and describes the functions that can be programmed to the XL Control Head and KMM
buttons:
FUNCTION
Accent Backlight
User Login
Adjust Squelch
Bluetooth
Enable/Disable
Caller ID
Channel Guard Override
CMD Mute
Direct System/Zone
Entry
Drop Call
Editable Preset
Emergency Check In
Timer
Fixed Preset
Front Backlight Mode
Home
Initiate Individual Call
Initiate Phone Call
Initiate OTAR
Lock Keypad
Monitor Toggle
102
When a KMM is used with the radio, the functions programmed to the one-dot,
two-dot, and three-dot buttons are the same for the KMM and Control Head.

Table 6-2: Programmable Button Options

Allows the radio user to change the backlight for the buttons on the XL mobile control
head.
Allows the user to enter a User ID and or Password to log into the P25 system (see
Section 4.4.1).
Allows the user to adjust the analog squelch level.
Enable/disable Bluetooth. See Section 5.10 for more information.
Opens the Caller ID menu.
Allows the user to pick a different Channel Guard setting for the current channel.
Mutes all audio. Audio remains muted until this button is pushed again or until an I-
Call is received by the radio.
Allows the user to select system/zone.
Drop or terminate any group call that the radio receives.
When this button is pressed and held for four (4) seconds, the radio saves the
currently selected System/group or Zone/channel to this button.
When this button is pressed and released in less than four (4) seconds, the radio
changes to the user-saved System/group or Zone/channel if already saved by the
user. If System/group or Zone/channel is not configured for this button, when the user
defined preset button is pressed and released in less than four (4) seconds, the radio
displays "Preset Empty."
When this button is pressed, the Emergency Check In Timer is activated. See Section
5.22 for more information.
When this button is pressed and released, the radio changes to the System/Group or
Zone/Channel specified in RPM2.
Toggles front display's backlight On/Off/Momentary/Momentary (Off).
Goes to home channel.
Initiate an Individual Call (See Section 4.14).
Initiate a phone call (see Section 4.22).
Initiate OTAR (see Section 5.19.7).
Locks the programmable function keys and navigation keys.
Toggles Monitor On/Off.
DESCRIPTION