Table of Contents
Advertisement
14221-1850-2000, Rev. C
1.
REGULATORY AND SAFETY INFORMATION
1.1
SAFETY SYMBOL CONVENTIONS
The following conventions are used in this manual to alert the user to general safety precautions
that must be observed during all phases of operation, installation, service, and repair of this
product. Failure to comply with these precautions or with specific warnings elsewhere violates
safety standards of design, manufacture, and intended use of the product. L3Harris assumes no
liability for the customer's failure to comply with these standards.
The WARNING symbol calls attention to a procedure, practice, or the like, which,
if not correctly performed or adhered to, could result in personal injury. Do not
proceed beyond a WARNING symbol until the conditions identified are fully
understood or met.
The CAUTION symbol calls attention to an operating procedure, practice, or the like,
which, if not performed correctly or adhered to, could result in damage to the equipment
or severely degrade equipment performance.
The NOTE symbol calls attention to supplemental information, which may improve
system performance or clarify a process or procedure.
NOTE
1.2
RF ENERGY EXPOSURE AWARENESS AND CONTROL
INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS
Before using the two-way mobile radio, review the following important RF energy
awareness and control information and operational instructions. Comply with this
information and instructions to ensure compliance with RF exposure guidelines.
This radio is intended for use in occupational/controlled conditions, where
users have full knowledge of their exposure and can exercise control over their
exposure to remain below RF exposure limits. This radio is NOT authorized for
general population, consumer, or any other use.
Changes or modifications not expressly approved by L3Harris could void the user's
authority to operate the equipment.
8
Advertisement
Table of Contents
