Installing Expansion Cards Inte The Bracket - Supermicro SuperServer SYS-211E-FRN13P User Manual

Installing Expansion Cards inte the Bracket

Both slots 1 and 2 can accommodate PCIe 5.0 x8 low-profile FHHL cards.
Installing PCI Expansion Cards
1. Remove the top cover.
2. Remove the card bracket from the chassis by unscrewing the screw holding the bracket
indicated in the figure below.
Figure 3-8. Removing the Expansion Card Bracket
3. Remove the card bracket from the chassis.
4. Remove the expansion card slot shield from the bracket.
5. Install the expansion card by sliding the card into the appropriate slot in the card
6. Secure the expansion cards to the bracket.
7. Install the entire assembly into the appropriate slot on the serverboard while aligning the
bracket with the front of the chassis and the metal cross bar.
8. Re-install the screw holding the bracket to the horizontal bar next to the fans.
Chapter 3: Maintenance and Component Installation
51
S
UPERMICR