Power Supply - Supermicro SuperServer SYS-211E-FRN13P User Manual

3.10 Power Supply

The server supports two 800 W AC (SYS-211E-FRN13P) or 600 W DC (SYS-211E-FRDN13P)
hot-swappable redundant power supplies. The power supplies are auto-switching capable. If
replacing a power supply, the system does not need to be powered down. New units can be
ordered directly from Supermicro or authorized distributors.
Replacing an AC Power Supply
1. Use the system's remote management to find the failed power supply.
2. Check the power supply's LED.
LED
3. Disconnect the power cord from the power strip or outlet.
4. Disconnect the power cord from the power supply inlet.
5. Push the release button towards the handle.
6. Using the handle, pull the power supply out of the chassis.
7. Slide the new power supply into the chassis until it clicks into place.
8. Reconnect the power cord to the power supply inlet.
9. Reconnect the power cord to the power strip or outlet.
10. Check the power supply's LED.
11. Use remote management to check the power supply status.
Chapter 3: Maintenance and Component Installation
Figure 3-12. AC Power Supply Front View
55