Table of Contents
Advertisement
Figure 2-8. Installing Front Screws onto the Rack
Note: Figures are for illustrative purposes only. Always install servers to the bottom of a rack
first.
2.7 Removing the Server from the Rack
To remove the system from the rack, perform the installation steps in reverse.
Removing the System
1. Remove the front screws.
2. Pull the chassis by the handles until the chassis is stopped by the locking tabs.
3. Press down on the locking tab while holding both side of the chassis.
4. Pull the chassis completely out of the rack.
Chapter 2: Server Installation
28
Advertisement
Table of Contents
Troubleshooting
