Supermicro SuperServer SYS-211E-FRN13P User Manual page 69

LAN1 Enable/Disable
Use jumper JPL1 to enable or disable LAN port 1. Refer to the table below for jumper settings.
TPM Enable
Use JPT1 to enable or disable the onboard TPM2.0. Refer to the table below for jumper
settings.
VGA Enable/Disable
Jumper JPG1 allows you to enable the onboard VGA connector. The default setting is pins
1-2 to enable the connection. Refer to the table below for jumper settings.
Power Force On
Use this jumper to select the "POWER FORCE ON" function when the AC power cord is
plugged in. When enabling force power on and AC power recovery, the system will boot up
automatically without pressing the power button.
LAN1 Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
TPM Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Power Force On
Jumper Settings
Jumper Setting Definition
Pins 1-2 Power Button On
Pins 2-3 Force Power Supply On
69
Chapter 4: Motherboard Connections