26 | DR 100e (Digital Radiography) | Introduction
Manual Collimator
6
5
4
Longitudinal collimation
1.
Button to switch on the light field indicating the collimated area and the
2.
laser light indicating the center position.
After pressing the button, they remain lit for a few seconds before
automatically switching off.
Rails to insert a DAP meter or a filter.
3.
Measurement tape to measure the distance between the focal spot of X-ray
4.
tube and the tabletop.
The measurement tape is at the rear side of the collimator.
Transversal collimation
5.
Filter selection.
6.
Another button to switch on the light field is available on the X-ray generator
control panel.
0365B EN 20181015 0853
1
2
3