Installing A So-Dimm Memory Module - Nexcom Neu-X304 Series User Manual

Chapter 3: System Setup

Installing a SO-DIMM Memory Module

1. The system has two SO-DIMM sockets, with one located on the top
side and the other on the bottom side of the motherboard. With the
top cover removed, install a memory module in the SO- DIMM socket.
Insert the module into the socket at an approximately 30-degree angle.
Push the module down until the clips on both sides of the socket lock
into position. The gold-plated connector on the edge of the module will
almost completely disappear inside the socket.
Copyright © 2024 NEXCOM International Co., Ltd. All Rights Reserved.
2. For 2 nd Memory module installation, remove the bottom cover and then
insert the module into the socket at an approximately 30-degree angle.
Push the module down until the clips on both sides of the socket lock
into position.
Memory Socket
31
Neu-X304 Series User Manual