4. To loosen the three setscrews (B) on the lens mount, use a 5 mm hex driver.
The setscrews must be backed out several turns to avoid contact with the inner lens mount
plate.
5. To fine tune the focus of cross-hair pattern I, adjust the appropriate adjustment screw (A)
until the cross-hair image is in focus with minimal flare.
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
52