Christie Cinema 2K-RBe Installation And Setup Manual page 57

The selected corner is indicated by a green circle. The X/Y pixel offset (from no correction)
displays in red, green, and blue text corresponding to each sprite.
9. Use the directional pad to move the sprites towards the center of the screen.
10. Adjust each sprite so they overlap to create a single white sprite.
In the example below, the red sprite (in image 1 below) was moved down and the blue sprite
(in image 1 below) was moved to the right so they overlap to create the single white sprite
(image 2 below).
11. To set the convergence for that corner of the screen, select Apply.
12. Repeat steps 7 to 10 for the remaining corners.
13. If necessary, reset the correction back to zero (no correction) or the previously saved
correction by selecting Reset.
In the Reset dialog, reset the current corner or all four corners. When the locations and value
are set, select Reset.
14. To save the current ECC settings, when the convergence is complete, select Save beside the
ILS file named at the top of the panel.
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright © 2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
1
Adjusting the image
2
57