S-Register List; S-Register Format - Paradyne COMSPHERE 3920PLUS Technical Reference Manual

COMSPHERE 392xPlus Modems

S-Register List

S-Registers affect the operating parameters of the 392xPlus modems. S-Registers are only
applicable when the DTE Dialer Type configuration option is set for AT. (Refer to the &Mn and
&Qn commands.)
Table 14-3
S-Register. The second column lists all possible values for that register. The third column lists the
key sequence used to enter the equivalent from the DCP. Use this column to refer to chapters about
the DCP menu branches if further description is necessary..

S-Register Format

S-Registers can be displayed and/or modified when the modem is in Command mode. To display
the value of an S-Register, issue the following command:
To modify the value of an S-Register, issue the following command:
In Table
Description column.
14-16
lists all S-Registers supported by the 392xPlus modems. The first column lists the
In some countries, the range of allowable values of some
S-Registers are restricted. If the DTE attempts to enter an illegal
value, the modem will answer OK, but it will set the register to the
closest legal value. The DTE can check the actual value of the
register with Sn? command.
TYPE: ATSn?
Where: n is the register number.
PRESS: Enter
TYPE: ATSn=r
Where: n is the register number, and r is the new value.
PRESS: Enter
14-3, the value for n is listed in the S-Register column, and the value for r is listed in the
NOTE
October 1998 3920-A2-GH30-40