Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 247

COMSPHERE 392xPlus Modems
AT
Command
\Nn Asynchronous Error Control Mode.
\N0
\N1
\N2
\N3
\N4
\N5
\N6
\N7
\Qn Asynchronous Flow Control of DTE, Asynchronous Flow Control of Modem.
\Tn No Data Disconnect Timer.
\T0
\Tn
NOTE: The factory default value is country dependent.
\Xn XON/XOFF Passthrough Flow Control.
\X0
\X1
%An Error Control Fallback Character.
%An
%Cn MNP5 Data Compression.
%C0
%C1
IHn
V.42bis Compression.
IH0
IH1
IH2
IH3
#DMn SDC Delay Minimization.
#DM0
#DM1
14-14
Table 14-2
392xPlus AT Commands
Description
Buffer Mode.
Direct Mode.
MNP or Disconnect.
MNP or Buffer.
V.42/MNP or Disconnect.
V.42/MNP or Buffer.
LAPM or Disconnect.
LAPM or Buffer.
Flow Control
of DTE:
\Q0 Disable
\Q1 XON/XOFF
\Q2 CTS to DTE
\Q3 CTS to DTE
\Q4 XON/XOFF
\Q5 Disable
\Q6 Disable
Disable.
Where n is a value from 1 to 255 in 1-minute increments.
Disable.
Enable.
Where n is an ASCII value from 0 to 127. Factory default is 013
ASCII.
Disable.
Enable.
Disable.
Enable (Transmit (TX) only).
Enable (Receive (RX) only).
Enable (Transmit (TX) and Receive (RX)).
No delay minimization. The modem does not begin transmitting a
frame to its DTE until the entire frame is received.
Delay minimization. The modem transmits data from a DTE frame
to its DTE even if the end of the DTE frame is not yet received
by the modem.
(9 of 10)
Flow Control
of Modem:
Disable
XON/XOFF
Disable
RTS to Mdm
Disable
XON/XOFF
RTS to Mdm
October 1998
DCP LCD
Command
Sequence
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
Line Dialer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42\MNP\Buffer
3920-A2-GH30-40