Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 149

COMSPHERE 392xPlus Modems
Test Timeout: Disable
Nxt Disable 30sec 60sec 240sec
Test Timeout. Determines how long a test runs before aborting.
Disable – Allows a test to run indefinitely.
30, 60, or 240 seconds – Allows the test to run for 30 seconds, 60 seconds, or 240 seconds.
The AT command is S-Register S18 = n, where n is 0 for Disable and 1 to 255 seconds.
Rcv Remote Loop: Enable
Nxt Enable Disable
Receive Remote Loopback Response. Determines if the modem responds to a request for a remote loopback issued
from a remote modem.
The AT command for Enable is &T4.
The AT command for Disable is &T5.
V54 Address: Disable
Nxt Disable (Address Values)
This configuration option does not appear when the modulation is TMp.
V.54 Address. Determines which remote 392xPlus modem is placed into a remote loopback test. This test can be either
a remote digital loopback or local analog loopback. This type of addressing should be used for extended data circuits
(tail circuits).
Disable – This is used for normal point-to-point leased-line and dial networks.
Address Values – 01, 03, 05, 07, 09, 0B, 0D, 0F, 11, 13, 15, 17, 19, 1B, 1D, 1F, 25, 27, 2B, 2D, 2F, 33, 35, 37, 3B, 3D,
3F, 55, 57, 5B, 5F, 6F, 77, or 7F. This configuration option selects the address of a modem that is to be placed into a
loopback test. This configuration option is used for more complex networks where multiple modems, used in extended
data circuits (tail circuits), can be commanded to loopback.
The AT command for Disable is S-Register S53 = 0.
The AT command for V.54 Address is S-Register S53 = n, where n is a value from 1 to 34.
V54 Device Type: Peripheral
End Peripheral Intermediate
This configuration option only appears when V54 Address is enabled and the modulation is not TMp.
V.54 Device Type. Identifies where the modem is physically located in the network.
Peripheral – The modem is located at the endpoint of the network and is not connected back-to-back with another
modem.
Intermediate – The modem is either of the two modems connected back-to-back.
The AT command for Peripheral is S-Register S54 = 0.
The AT command for Intermediate is S-Register S54 = 1.
5-72
Table 5-13
(2 of 2)
Test Configuration Options — Singleport Mode A
October 1998 3920-A2-GH30-40