If the edited VF thresholds are valid, the Save command stores them into nonvolatile memory.
When the Save completes, the message Save Completed appears.
If the edited VF threshold is invalid (out of range), the error message Thd Out of Range
appears. This indicates the Save procedure was unsuccessful. Return to the Edit screen and
correct the invalid threshold range.
To correct the invalid VF threshold, press the
Edit/Save/Reset screen.
Select Reset to restore the original default values into memory.
Repeat the Edit and Save procedure until the VF threshold(s) is valid and the Save completes
successfully (Save Completed).
To exit this function and remain in the Control branch, press the
the Top-Level menu, press the
Health and Status VF alarms are reported to the front panel LED and the Network Management
System (NMS) based on the parameters in
and Status (DeviceHS) section of Chapter 4, Status Branch, for Health and Status VF message
alarm information.
3920-A2-GH30-40
Save VF Thresh
Thd Out of Range
F1
F2
F3
VF Thresholds
Edit
Save
Reset
F1
F2
F3
key.
October 1998
key to return to the VF Threshold
key. To exit and return to
Table
7-1. Refer to
Table 4-1
Control Branch
in the Device Health
7-19