Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 176

If unsuccessful, the modem remains in the Download Transfer mode. The LCD's top line
displays RemClone Failed and the bottom line displays one of the following messages:
Incompat Modulat
No Response
Access Disabled
Password Invalid
No Circuit
After successful establishment of a Remote Cloning Download session, the following screens
appear.
As the firmware transfers, the local and remote LCD's bottom line displays the status of the
download process, plus the number of records sent versus the total number of records for that
data bank number.
For Single download applications, if the download is successful, the local modem displays
Remote Clone OK and the remote modem displays Frmware Upgrade. If the download took
place over the dial network, the modems disconnect when the download is complete.
If the Single download is unsuccessful, RemClone Failed appears on the LCD's top line.
Attempt another download from the local modem. If this fails, contact your service
representative.
3920-A2-GH30-40
The modems are connected, but are using a modulation scheme other
than V.34 family, V.33, V.32 family, V.29, or TMp.
The remote modem is not a 3900 Series modem or the connection
between the two modems is poor.
The remote modem's Access from Remote configuration is disabled.
The local and remote modems' passwords do not match. Correct the
problem and attempt another download from the local modem. If this
fails, contact your service representative.
There is no connection between the local and remote modem.
RemClone Status
Initializing
F1 F2 F3
RemClone Status
Bank1:xxxx/yyyy
F1 F2 F3
October 1998
Control Branch
7-15