Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 170

Selecting Clone Remote
To access DwnLoadSoftware from the Control branch, make the following selections:
Press the
Download_Code. The DwnLoadSoftware screen appears.
Press any function key to select Clone_Remote.
The next screen to appear is determined by the modem's configuration. Refer to the appropriate
section based on your modem's configuration; Clone Remote in Point-to-Point Configurations,
Clone Remote in Broadcast Configurations, or Clone Remote in Multipoint Configuration.
Clone Remote in Point-to-Point Configurations
Before using Clone Remote in point-to-point configurations, verify the following:
• The 392xPlus modems have an established leased-line connection using either V.34
• The remote modem's Access From Remote configuration option is enabled (refer to the
• The password (Remote Access Password configuration option) is the same in both the
After completing these checks, proceed to the section titled
Operation, which follows the descriptions of multipoint cloning operations.
3920-A2-GH30-40
Clone Remote operations are not supported unless both local and
remote modems are 392xPlus modems. (The 3800 or 391x Series
modems cannot be used in cloning operations with 392xPlus
modems.)
Control:
Download_Code
F1 F2
key until Download_Code appears. Press any function key to select
DwnLoadSoftware >
Clone_Remote
F1 F2
family, V.33, V.32 family, or V.29 modulation (refer to the Leased Line section in
Chapter 5, Configure Branch.) or a dial network connection using either V.34 family or
V.32 family modulations (refer to the Dial Line section in Chapter 5, Configure Branch).
Misc section in Chapter 5, Configure Branch).
local and remote modems. (For an example of how to change the password, refer to the
Editing and Saving a Configuration Option
October 1998
NOTE
F3
F3
section in Chapter 5, Configure Branch.)
Implementing a Clone Remote
Control Branch
7-9