Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 246

AT
Command
&Zn=x Store Telephone Numbers. Modem saves the telephone numbers and dial
command modifiers (if any) entered for x (up to 40 characters in length) in
Directory Location n (1–24). For example, the command AT&Z1 = 5551234
stores the telephone number 555-1234 into directory location 1.
To clear a telephone number from a memory location, issue the &Zn =x command
without entering a telephone number.
\An Maximum Frame Size.
\A0
\A1
\A2
\A3
\A4
\A5
\Cn Error Control Negotiate Buffer.
\C0
\C1
\C2
\Dn CTS Control.
\D0
\D1
\D2
\D3
\D4
\Gn Modem to Modem Flow Control.
\G0
\G1
\Kn Break Buffer Control, Send Break Control, Break Forces Escape.
3920-A2-GH30-40
Table 14-2
392xPlus AT Commands
Description
64 bytes.
128 bytes.
192 bytes.
256 bytes.
32 bytes.
16 bytes.
Disable.
Enable.
Disables and switches modem to Buffer mode.
Forced On. Forces CTS to always ON.
Standard RS232.
Wink When Disconnect. CTS is turned OFF for 1 to 2 seconds upon a
disconnect.
Follows DTR. The state of CTS follows the state of DTR.
Follows RTS. The state of CTS follows the state of RTS.
Disable.
Enable.
Break Buffer
Control:
\K0 Discard Data
\K1 Discard Data
\K2 Keep Data
\K3 Keep Data
\K4 Keep Data
\K5 Keep Data
(8 of 10)
Send Break Break Forces
Control: Escape:
Break First Enable
Break First Disable
Break First Enable
Break First Disable
Data First Enable
Data First Disable
October 1998
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Call Setup\
Change Directory
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
DTE Interface
Configure\Edit\
V42/MNP/Buffer
Break Buffer
Control:
Configure\Edit\
V42/MNP/
Send Break
Control:
Configure\Edit\
V42/MNP/Buffer
Break Forces
Escape:
Configure\Edit\
DTE Dialer
14-13