Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 164

Reset
Reset causes the modem to stop operation and perform a complete program restart. The
modem begins the power-up test sequence that ends with the Top-Level menu displayed on
the LCD. Configuration options stored in an Active (Saved) configuration area are copied to
the Active (Operating) configuration area.
To access Reset from the Control branch, make the following selection:
Select Reset.
The message Reset appears momentarily before the modem performs the power-up diagnostic
test sequence.
Data Stream
Use Data Stream to enable or disable the modem's data transmitter function on a specific port or
on all ports.
The Data Stream function is not available in Singleport mode with configuration option
Async/Sync Mode set to Async, or when Synchronous Data Compression is enabled.
To access Data Stream from the Control branch, make the following selections:
Press the
If the mux is enabled, press the
Port1, Port2, Port3, Port4, or All. For information on selecting All, refer to
later in this section.
To select a port, press the appropriate function key (F1 or F3).
This screen does not appear if in Singleport mode or the DTE Bridge configuration option is
enabled.
3920-A2-GH30-40
Control: >
Speaker Reset
F3
F1 F2
Control:
Data_Stream
F1 F2 F3
key until Data Stream appears. Select Data Stream (F1).
Select DS Port >
Port1 Port2
F1 F2 F3
key to scroll the available ports into view. You may see
October 1998
Control Branch
Selecting All Ports
7-3