Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 129

COMSPHERE 392xPlus Modems
No Data Disc: Disable
Nxt Disable 10min 30min 60min
No Data Disconnect. Forces the modem to disconnect if no data is transmitted and received within a specified amount
of time.
Disable – Modem remains connected despite the lack of data flow.
10, 30, 60 min – Modem disconnects if data is not received and transmitted within 10-minute, 30-minute, or 60-minute
intervals.
NOTE: The factory default value is country dependent.
The AT command for Enable is \Tn, where n is from 1 minute to 255 minutes.
The AT command for Disable is \T0.
Auto Make Busy: Disable
Nxt Disable Enable
This option is only valid on Model 3921Plus.
Automatic Make Busy. Forces the modem to go off-hook under the following conditions: if a local analog loopback is
performed, a self-test is performed, or if the modem is switched to the service line.
NOTE: This configuration option should only be used when the modem is located behind a user's Private Branch
Exchange (PBX). The Make Busy Network Interface Module (NIM) must be installed on the COMSPHERE
3000 Series Carrier. Refer to the COMSPHERE 3000 Series Carrier, Installation Manual.
The AT command is S-Register S40 = n, where n is 0 for Disable and 1 for Enable.
MakeBusyVia DTR: Disable
End Disable Enable
Make Busy Via DTR. Determines if the modem goes off-hook when DTR is OFF. Enable this setting if the DTE normally
keeps DTR ON and turns DTR OFF when the DTE cannot accept a call.
NOTE: This configuration option should only be used when the modem is located behind a user's Private Branch
Exchange (PBX). For 3921Plus modems, the Make Busy Network Interface Modules (NIMs) must be installed
on the COMSPHERE 3000 Series Carrier. Refer to the COMSPHERE 3000 Series Carrier, Installation Manual.
The AT command is S-Register S69 = n, where n is 0 for Disable and 1 for Enable.
5-52
Line Dialer Configuration Options — Singleport Mode A
Table 5-9
(4 of 4)
October 1998 3920-A2-GH30-40