Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 127

COMSPHERE 392xPlus Modems
DialTone Detect: Enable
Nxt Enable Disable
Dial Tone Detect. Sets the modem for dial tone detection (Enable) or blind dialing (Disable).
Enable – Modem disconnects the call if a dial tone is not detected within 10 seconds and displays No Dial Tone on
both the LCD and asynchronous DTE terminal.
Disable – Modem dials a call whether or not it detects a dial tone on the line. This is known as blind dialing. The period
of time the modem waits before dialing is specified in the Blind Dial Pause configuration option.
NOTE: It may not be possible to disable Dial Tone Detect in some countries.
The AT commands for Disable are X0, X1, and X3.
The AT commands for Enable are X2, X4, X5, X6, and X7.
Blind Dial Paus: 2sec
Nxt 2sec 4sec 6sec 8sec 10sec 20sec
This configuration option only appears when Dial Tone Detect is configured for Disable.
Blind Dial Pause. Determines how long the modem waits before dialing a telephone number when Dialtone Detect is
disabled.
NOTE: The range of allowable values may be restricted in some countries.
The AT command is S-Register S6 = n, where n is from 2 to 255 in 1-second increments.
BusyTone Detect: Enable
Nxt Enable Disable
Busy Tone Detect. Sets the modem to monitor for Busy Tone (Enable) or ignore Busy Tone (Disable).
NOTE: This configuration option is normally enabled; however, if the modem receives false busy tones, this
configuration option can be disabled and the modem ignores all busy tones.
The AT commands for Disable are X0, X1, and X2.
The AT commands for Enable are X3, X4, X5, X6, and X7.
"," Pause Time: 2sec
Nxt 2sec 4sec 6sec 8sec 10sec 20sec
Pause Time. Determines the number of seconds the modem pauses when it encounters a comma (,) in the dial
command string.
NOTE: Although DCP selections are limited (2, 4, 6, 8, 10, or 20), values set by the AT commands can display from 0 to
255 seconds.
The AT command is S-Register S8 = n, where n is from 0 to 255 in 1-second increments.
NoAnswer Timout: 45sec
Nxt 45sec 30sec 60sec
No Answer Abort Timeout. Determines the number of seconds an originating modem waits before abandoning a call
attempt when no answer tone is received.
NOTE: Although DCP selections are limited (30, 45, or 60), values set by AT commands can display from 1 to
255 seconds.
NOTE: The range of allowable values may be restricted in some countries.
The AT command is S-Register S7 = n, where n is from 1 to 255 in 1-second increments.
5-50
Line Dialer Configuration Options — Singleport Mode A
Table 5-9
(2 of 4)
October 1998 3920-A2-GH30-40