Paradyne COMSPHERE 3920PLUS Technical Reference Manual page 109

COMSPHERE 392xPlus Modems
Miscellaneous Configuration Options — Multiport Mode l
Dir#1_Callback: Disable
Nxt Disable Enable
Directory Location 1 Callback. This configuration option controls whether or not the modem's single number callback
function is used.
Disable – Modem does not use the single number callback function.
Enable – Modem answers a call, disconnects, and dials the number stored in directory location 1.
Callback Delay: Disable
Nxt Disable 20sec 40sec 1min 2min 3min
This configuration option only appears if Dir#1 Callback is enabled.
Callback Delay. Determines the amount of time between disconnect confirmation and callback origination.
Disable – No time is specified. The default delay is 10 seconds.
20sec – 3min – The delay is set to the specified duration.
SpecialSecurity: Disable
Nxt Disable RemAccsPswd CallbkDir#
This configuration option only appears when the modem is in Dial Only mode or Lease Answer Mode, and
Answer Security Mode is configured for No_Answ_Sec.
Special Security. Provides two types of security that are not as rigorous as the standard security described in Chapter
12, Dial Access Security. Special Security is not restricted to Asynchronous or Singleport Mode.
Disable – No callback directory number or remote access password reception are required to answer a call. The
Dir#1_Callback configuration option can be used, or no callback security can be used.
RemAccsPswd – The modem uses its remote access password. A matching remote access password must be
transmitted as an 8-digit tone from the originating modem (like a VF password) before the answering modem will accept
the call. The answering modem will disconnect the call if no password is received within the entry wait timeout or the
received password does not match the remote access password.
CallbkDir# – When selected, the remote callback directory number must be transmitted as a 2-digit tone from the
originating modem (like a VF password) before the answering modem will accept the call. The answering modem will
disconnect the call after receiving the callback directory number or when the entry wait timeout expires. If the received
directory number is valid, the answering modem uses it to locate the phone number of the originating modem for
callback.
NOTE: This selection only appears when Dir#1_Callback configuration option is set to Enable.
EntryWait_Time: 20 sec
Nxt 20 sec 10 sec 40 sec 60 sec
This configuration option only appears when the Special Security configuration option is set to RemAccsPswd
or CallbkDir#.
Entry Wait Timeout. Determines how long the answering modem waits for the originating modem to enter a VF-side
password.
5-32
Table 5-6
(2 of 4)
October 1998 3920-A2-GH30-40