Remote At Command Request Frame - 0X17 - Digi XBee-PRO S2C Zigbee User Manual

API Operation

Remote AT Command Request frame - 0x17

Description
Used to query or set device parameters on a remote device. For parameter changes on the remote
device to take effect, you must apply changes, either by setting the Apply Changes options bit, or by
sending an AC command to the remote.
Format
The following table provides the contents of the frame. For details on frame structure, see
format.
Frame
data
fields Offset Description
Frame 3
type
Frame ID 4
64-bit 5-12
destination
address
16-bit 13-14
destination
address
Remote
15
command
options
AT
16-17
command
Command
18-n
parameter
Example
The following example sends a remote command:
In this example, the 64-bit address of the remote device is 0x0013A200 40401122. The destination 16-
bit address is unknown.
XBee/XBee-PRO® S2C Zigbee® RF Module
0x17
Identifies the data frame for the host to correlate with a subsequent ACK. If
set to 0, the device does not send a response.
MSB first, LSB last. Set to the 64-bit address of the destination device.
Reserved 64-bit address for the coordinator = 0x0000000000000000
Set to 0xFFFE if the address is unknown, or if sending a broadcast.
Bitfield to enable various remote command options. Supported values include:
0x01 - Disable ACK
0x40 - Use the extended transmission timeout for this destination. Setting the
extended timeout bit causes the stack to set the extended transmission
timeout for the destination address.
For more information, see
Command name: two ASCII characters that identify the command.
If present, indicates the parameter value you request for a given register. If
no characters are present, it queries the register.
Transmission, addressing, and
Frame descriptions
API frame
routing.
167