Load Zigbee Firmware - Digi XBee-PRO S2C Zigbee User Manual

Load Zigbee firmware on 802.15.4 devices

Load Zigbee firmware

To load Zigbee firmware on an existing 802.15.4 module, use the following instructions. You must use
the serial interface to perform this update. The device does not support OTA updates for changing
802.15.4 to ZB firmware or vice versa.
1. Verify that your device's part number (listed on the label) is included in the list shown in the
table above.
2. Install the device in a Digi development board and connect it to your PC.
3. The next steps involve loading firmware using XCTU. To download XCTU and read detailed
instructions about it, go to:
https://www.digi.com/products/xbee-rf-solutions/xctu-software/xctu
4. When you get to the Update firmware dialog box, in the Function set area, click the Zigbee
option, and the newest firmware version.
5. Click Update and follow the instructions.
6. When the updating process successfully completes, your device runs Zigbee firmware. You can
change back to 802.15.4 firmware at any time by following the same process and selecting the
802.15.4 firmware option instead.
XBee/XBee-PRO® S2C Zigbee® RF Module
Load Zigbee firmware
303