Explicit Rx Indicator Frame - 0X91 - Digi XBee-PRO S2C Zigbee User Manual

API Operation

Explicit Rx Indicator frame - 0x91

Description
When a device configured with explicit API Rx Indicator (AO = 1) receives an RF packet, it sends it out
the serial interface using this message type.
Note If a Transmit Request frame - 0x10
a 0x91 frame with the Source endpoint (SE), Destination endpoint (DE), and Cluster ID (CI) values, and
not the values set on the transmitting device in Transparent mode .
The Cluster ID and endpoints must be used to identify the type of transaction that occurred.
Format
The following table provides the contents of the frame. For details on frame structure, see
format.
Frame
data fields Offset Description
Frame type 3
64-bit
4-11
source
address
16-bit
12-13
source
network
address
Source
14
endpoint
Destination
15
endpoint
Cluster ID
16-17
Profile ID
18-19
XBee/XBee-PRO® S2C Zigbee® RF Module
is sent to a device with AO = 1, the receiving device receives
0x91
MSB first, LSB last. The sender's 64-bit address. Set to 0xFFFFFFFFFFFFFFFF
(unknown 64-bit address) if the sender's 64-bit address is unknown.
The sender's 16-bit address.
Endpoint of the source that initiates transmission. The default value is shown
when Transmit Request frame - 0x10
Non-defaults are shown if
to send data from the source, or if a non-default value was used, otherwise
the default value remains.
Endpoint of the destination that the message is addressed to. The default
value is shown when Transmit Request frame - 0x10
the source. Non-defaults are shown if
0x11 is used to send data from the source, or if a non-default value was used,
otherwise the default value remains.
The Cluster ID that the frame is addressed to. The default value is shown
when Transmit Request frame - 0x10
Non-defaults are shown if
to send data from the source, or if a non-default value was used, otherwise
the default value remains.
The Profile ID that the fame is addressed to.
is used to send data from the source.
Explicit Addressing Command frame - 0x11
Explicit Addressing Command frame -
is used to send data from the source.
Explicit Addressing Command frame - 0x11
Frame descriptions
API frame
is used
is used to send data from
is used
179