Pd (Pull Up/Down Direction); Rp Command; Dc Command - Digi XBee-PRO S2C Zigbee User Manual

AT commands
Bit I/O line
On/SLEEP/DIO9
9
10 DIO12
11 PWM0/RSSI/DIO10/
12 PWM1/DIO11
CTS/DIO7
13
14 DOUT/DIO13
Parameter range
0 - 0x7FFF (bit field)
Default
0x1FFF

PD (Pull Up/Down Direction)

The resistor pull direction bit field (1 = pull-up, 0 = pull-down) for corresponding I/O lines that are set
by the PR command.
If the bit is set, the device uses an internal pull-up resistor. If it is clear, the device uses an internal
pull-down resistor. See the PR command for the bit order.
Parameter range
0x0 - 0x7FFF
Default
0x1FBF

RP command

The PWM timer expiration in 0.1 seconds. RP sets the duration of pulse width modulation (PWM) signal
output on the RSSI pin. The signal duty cycle updates with each received packet and shuts off when
the timer expires.
When RP = 0xFF, the output is always on.
Parameter range
0 - 0xFF (x 100 ms)
Default
0x28 (four seconds)

DC command

Bit settings to enable or disable certain behaviors.
Bit field:
Bit settings to enable or disable certain behaviors.
XBee/XBee-PRO® S2C Zigbee® RF Module
I/O settings commands
Module pin
26/SMT, 13/TH
5/SMT, 4/TH
7/SMT, 6/TH
8/SMT, 7/TH
25/SMT, 12/TH
3/SMT, 2/TH
247