Accessing And Displaying Configuration Options; Saving Configuration Options - Paradyne 7610 User Manual

Accessing and Displaying Configuration Options

Saving Configuration Options

7610-A2-GB20-00
To display the configuration options, you must first copy one configuration option
set into the edit area.
Procedure
1. To load a configuration option set into the configuration edit area, follow this
menu selection sequence:
Main Menu Configuration
2. Select one of the four configuration option areas listed in the table in
Configuration Option Areas
set is loaded and the Configuration Edit/Display menu screen appears.
No configuration edits are allowed when the effective access level is 2 or 3.
Configuration is read-only and allows viewing only of configuration option
settings. If the effective access level is not an access level of 1:
— The last line of the Load Configuration From screen reads:
Access Level is n , Configuration is read-only
— The Save prompt will not appear on any screens.
Security
Refer to , Chapter 4.
When changes are made to the configuration options, the changes must be
saved to take effect. The Save key and Save Configuration To screen appear
when the user has an effective access level of 1. All other effective access levels
have read-only permission.
To save configuration options changes:
Procedure
1. Press Ctrl-a to switch to the screen function key area below the dotted line.
2. Select Save and press Return. The Save Configuration To screen appears.
3. Select one of the three configuration option areas on the screen and press
Return. When Save is complete, Command Complete appears in the
message area at the bottom of the screen.
NOTE:
When Exit is selected before Save, a Save Configuration screen appears
requiring a Yes or No response.
If you select . . .
Yes
No
November 1996
Load Configuration From
. Press Return. The selected configuration option
Then . . .
The Save Configuration To screen appears.
The Main Menu appears and changes are not saved.
Start-Up
3-5