Creating A Login - Paradyne 7610 User Manual

Security

Creating a Login

4-2
Logins apply to Terminal port and Telnet access to the ATI. Six login ID/password
combinations are available. Each Login ID and Password must be unique and
include an access level.
For additional information regarding the ATI access using the Login Required
option, refer to the ATI Access
Procedure
1. To create a login record, follow this menu selection sequence:
Main Menu Control
2. Press Ctrl-a to switch to the screen function key area below the dotted line.
3. Select New and press Return.
4. Create the login by entering the following fields. For valid entries in the first
two fields, refer to the
On the Administer
Logins screen, for the . . . Enter . . .
Login ID
Password
Access Level
NOTE:
Assign at least one Level 1 Access Level. Full access is necessary to
make configuration option changes and administer logins. If there is no
effective access level 1, refer to the
5. Press Ctrl-a to switch to the screen function key area below the dotted line.
Select Save and press Return.
6. When Save is complete, Command Complete appears at the bottom of the
screen. The cursor is repositioned at the Login ID field, ready for another
entry.
November 1996
section .
Administer Logins
ASCII Characters section of Appendix A.
1 to 10 ASCII printable characters
1 to 10 ASCII printable characters
Level 1, Level 2, or Level 3
Device Reset section of Chapter 7.
7610-A2-GB20-00