Unit Status; Viewing Health And Status - Paradyne 7610 User Manual

Unit Status

Viewing Health and Status

7610-A2-GB20-00
Status is a branch of the ATI main menu. From Status, the System and Test
Status screen is available and has three sections:
Health and Status – Displays messages in priority order (highest to lowest).
Refer to Health and Status
Self-Test Results – Results of the Diagnostic test run on the device itself.
Refer to Self-Test Results
Test Status – Currently active tests. Refer to
Table 7-1.
To view Health and Status information, follow this menu selection sequence:
Main Menu Status
The following messages appear in the first column of the System and Test Status
screen. The highest priority Health and Status message also appears on all ATI
screens on the bottom right. The messages are listed from high to low priority in
Table 6-1.
Table 6-1. Health and Status Messages (1 of 2)
Message What Message Indicates
Cross Pair The DDS Receive (RX) and
Detection Transmit (TX) pairs are
crossed on the network
interface. Alarm LED is on.
No Signal No signal is being received.
1
hhh:mm:ss Local DSU network problem.
The Alarm and NS LEDs are
on and Network Performance
Statistics are active.
Out of Service DSU is receiving out of
1
hhh:mm:ss service code from the
network for the remote unit.
The Alarm and OOS LEDs
are on and Network
Performance Statistics are
active.
1
hhh:mm:ss indicates the amount of time the condition has existed in hours, minutes,
and seconds. When the maximum time has been exceeded, 255:59:59+ appears.
November 1996
Messages, Table 6-1.
Messages, Table 6-2.
Test Status
System and Test Status
What To Do
Reverse the RX and TX pair at the
punchdown block or other
termination point.
1. Verify that the network cable is
securely attached at both ends.
2. Contact network provider.
1. Verify that the remote site is in
service.
2. Contact network provider.
Monitoring the DSU
Messages,
6-5