Telnet Session Options - Paradyne 7610 User Manual

Configuration Option Tables

Telnet Session Options

A-18
Table A-6. External Device Options (3 of 3)
Disconnect String
Possible Settings: ASCII Text, Clear
Default Setting: [blank]
The Disconnect String specifies the command used to disconnect an external device.
The external device must be in command mode, so the Escape Sequence is always
sent before the Disconnect String.
Disconnect String option appears when External Device Commands is set to
Other.
ASCII Text – Enter a maximum of 20 characters. Refer to the
for valid ASCII characters and control sequences.
Clear – Clears the field and sets to no string. The Management port DSR lead is used
to force a disconnect.
To access the Telnet Session Options screen, follow this menu selection
sequence:
Main Menu Configuration
User Interface Telnet Session
Table A-7. Telnet Session Options (1 of 2)
Telnet Session
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies if the DSU will respond to a Telnet session request from a Telnet client on an
interconnected IP network.
Enable – Allows Telnet sessions between the unit and a Telnet client.
Disable – No Telnet sessions allowed.
Login Required
Possible Settings: Enable, Disable
Default Setting: Disable
Used to secure access to the ATI through a Telnet session. Login IDs are created with a
password and access level. Refer to the
Enable – Security is enabled. When access is attempted via Telnet, the user is
prompted for a Login ID and password.
Disable – No Login required for a Telnet session.
November 1996
ASCII Characters
Load Configuration From
Creating a Login section of Chapter 4.
section
Edit
7610-A2-GB20-00