Paradyne 7610 User Manual page 68

Configuration Option Tables
A-8
Table A-2. Network Interface Options (4 of 4)
In-Band Framing Alarm
Possible Settings: Enable, Disable
Default Setting: Enable
When an in-band framing condition is detected on the network interface, an ASCII alarm
is generated.
In-Band Framing Alarm option does not appear when the In-Band Management
Channel Rate (bps) is disabled.
Enable – Generates an ASCII alarm when a in-band framing condition is detected.
Disable – No ASCII alarm is generated.
NOTE: Additional settings are required to send out an ASCII alarm. Refer to the
Alarm Messages
November 1996
section in Chapter 8.
7610-A2-GB20-00