Alarms & Traps Options Menu - Paradyne 7610 User Manual

Configuration Option Tables
Alarms & Traps Options Menu
A-20
For Alarms & Traps Options, refer to Table A-8. To access the Alarms & Traps
Options screen, follow this menu selection sequence:
Main Menu Configuration
Alarms & Traps
Table A-8. Alarms & Traps Options (1 of 2)
ASCII Alarm Messages
Possible Settings: Enable, Disable
Default Setting: Disable
Controls the generation and routing of ASCII alarm messages to an ASCII terminal or
printer connected to the Management port. Refer to the
Chapter 8.
Enable – ASCII alarm messages are generated and sent out when the Management
port is configured for Alarms in
The messages are sent out immediately if there is:
– No DCE (e.g., modem or PAD) connected to the Management port and
External Device Commands
– An active connection is already established via an external DCE.
If an external device is connected to the Management port with no active
connection, the message control is based on the next option, Alarm & Trap
Dial-Out. External Device Commands must be configured for AT or Other in
External Device Options, Table A-6.
Disable – ASCII alarm messages are not generated or sent.
Alarm & Trap Dial-Out
Possible Settings: Enable, Disable
Default Setting: Disable
When there is no active connection, this option controls whether generating an ASCII
alarm or SNMP trap results in automatic call initiation.
Enable – Automatically places a call via the external device connected to the
Management port.
To send out SNMP traps,
When Port Use is set to Net Link in Table A-5, up to ten SNMP traps are queued
at the interface.
The Primary Directory phone number is dialed. Refer to the
Chapter 3.
Refer to the Call Retry
Disable – Automatic call initiation is disabled and alarm messages are discarded.
SNMP traps are retained until a connection is established.
November 1996
Load Configuration From
Management Port Options,
option is set to Disable in Table A-6 or
SNMP Management must be enabled in Table A-10.
option for handling of incomplete call attempts.
Edit
Alarm Messages section of
Table A-5.
Call Setup section of
7610-A2-GB20-00