Paradyne 7610 User Manual page 110

MIB Descriptions
Input Signal Table Objects
C-16
Table C-10. Synchronous Port Table Objects (2 of 2)
Object Description
rs232SyncPort Reports the interval (in
RTSCTSDelay milliseconds) that the port
(rs232Sync
waits after RTS is asserted
PortEntry 11 )
before asserting CTS.
rs232SyncPort Specifies the port's mode of
Mode data transfer.
(rs232Sync
PortEntry 12 )
The following are not supported:
rs232SyncPortIdle Pattern (rs232SyncPortEntry 13)
rs232SyncPortMinFlags (rs232SyncPortEntry 14)
The Input Signal Table Objects contains entries for the input signals that can be
detected by the unit for the synchronous user data port. Clarification for objects
contained in this table as it applies to the unit is provided below.
Table C-11. Input Signal Table Objects
Object Description
rs232InSigName Contains the identification
(rs232InSigEntry 2 )
of a hardware input signal.
rs232InSigState Contains the current signal
(rs232InSigEntry 3 ) state.
rs232InSigChanges Indicates the number of
(rs232InSigEntry 4 ) times that a signal has
changed from on to off, or
off to on.
November 1996
Setting/Contents
Supports only the following read-only
values:
0 – The port does not have to wait. Only
valid for Management port.
integer number – represents
milliseconds. It is only valid for the user
data port, when Carrier Control by RTS
is set to Switched and corresponds to
approximately 21 bit time intervals at the
operating DDS rate.
Supports only the following value:
fdx(1) – Full-duplex
Setting/Contents
Supports only the following values:
rts(1) – Request To Send
dtr(4) – Data Terminal Ready
Supports only the following values:
on(2) – The signal is asserted
off(3) – The signal is deasserted
The object is incremented each
time that the signal is sampled
(every 100 ms) and the signal state
is different from the previous state.
7610-A2-GB20-00