Attaching A Video Input - Matrox Corona Installation And Hardware Reference

28 Chapter 2: Hardware installation
Connecting external
devices to the
encoder's output
Analog video input
Matrox Corona's optional encoder can encode displayed output
and send it to NTSC/PAL and RGB external video devices,
through the video input connector. To connect these devices to
this connector, use the optional DBHD44-TO-8BNC cable.
Three of the cable's eight BNC connectors are used for output.
These wires are color-coded as follows:
Wires Signals
White RED_C_OUT
Yellow GREEN_Y_OUT
Purple BLUE_COMP_OUT Encoded Video Output

Attaching a video input

Matrox Corona supports a wide variety of analog and digital
video sources.
Attach analog video sources to Matrox Corona's video input
connector, using the optional DBHD44-TO-8BNC cable. Five of
the cable's eight BNC connectors are used for input. These wires
are color-coded as follows:
Wires Signals
Red VID_IN1
Green VID_IN2
Blue VID_IN3
Black VID_IN4
Gray OPTOTRIG
Connect the two BNC-TO-SVHS adaptor cables to the
DBHD44-TO-8BNC cable for Y/C inputs.
Refer to Appendix B for additional signals offered through the
DB-44 video input connector.
Expected input
Encoded Video Output
(C or red).
Encoded Video Output
(Y or green).
(CVBS or blue).
Expected input
Analog Video Input1
(CVBS, Y1, or red).
Analog Video Input2
(CVBS, C1, or green).
Analog Video Input3
(CVBS, Y2, or blue).
Analog Video Input4
(CVBS, C2, or sync).
External trigger input.