Inspecting The Matrox Corona Package; Standard Package; Optional Parts - Matrox Corona Installation And Hardware Reference

16 Chapter 1: Introduction

Inspecting the Matrox Corona package

Standard package

When you unpack your Matrox Corona package, you should
check its contents. Note that optional parts will only be included
if ordered. If something is missing or damaged, contact your
Matrox representative.
If you ordered Matrox Corona, you should receive the following
items:
The Matrox Corona board, with a PCI board retainer
attached.
The Matrox Corona Installation and Hardware Reference
manual (this document).
A 4-pin power cable.

Optional parts

You might have also ordered one or more of the following:
MIL/CD or MIL-Lite/CD (both include ActiveMIL-Lite &
Intellicam).
Inspector-32/CD.
DBHD44-TO-8BNC (7-foot (2.13 m) input cable with a high
density 44-pin male connector and eight BNC-type
connectors). Two BNC-TO-SVHS (adaptor cables for Y/C
input) are shipped with the DBHD44-TO-8BNC cable.
DH44-TO-8BNC/O (3-foot (91.44 cm) input cable with a high
density DB-44 male connector on one end and both an
open-ended wire and eight BNC-type connectors on the other
end).
An ISA/PCI-based, RS-422/LVDS companion digital-input
board designed for Matrox Corona (COR-DIG-BRD/R or
COR-DIG-BRD/L). A ribbon cable and backplane is shipped
with the board to connect it to Matrox Corona's digital
interface connector. A PCI bracket is also included to install
the board in a PCI slot.