Camera Power Supply Connector; Dip Switches - Matrox Corona Installation And Hardware Reference

86 Appendix B: Technical information





Camera power supply connector

The camera power supply connector is a standard 4-pin male
connector. The pinout is as follows:
Pin Voltage
1 +12 V
2 Ground
3 Ground
4 +5 V
The part number is as follows:
Manufacturer:
Connector:

DIP switches

The DIP switches allow you to control whether the BIOS is
protected, Matrox Corona's VGA is enabled, and the interrupt
line.
DIP switch 1 (SW1) settings:
Position 1
off BIOS protected
(default)
on BIOS unprotected
DIP switch 2 (SW2) settings:
PCI interrupt Position 1
request line
Interrupt A off
(default)
Interrupt B on
Interrupt C off
Interrupt D on
VEN
2490-04PRT
Position 2
Matrox Corona's VGA enabled
(default)
Matrox Corona's
VGA disabled
Position 2
off
off
on
on