Choosing Your Display Configuration - Matrox Corona Installation And Hardware Reference

22 Chapter 2: Hardware installation
10. Attach your monitor(s) and input video sources. For details,
see the Connecting external devices section.
11. Turn on your computer.
Under Windows 95, when you boot your PC, Windows'
Plug-and-Play system will detect a new PCI Multimedia
Video Device and you will be asked to assign it a driver. At
this point, you should click on Cancel.
Note that when you select Cancel in older versions of
Windows 95, Windows 95 will log the device as
unidentified. Since you cannot run MIL-Lite while
Windows detects an unidentified device, run the System
utility from the Control Panel, select the Device
Manager property sheet, and under the Other Devices
option, remove "PCI Multimedia Video Device". Now, you
can install MIL-Lite. If MIL-Lite was already installed,
you need to uninstall and reinstall it.

Choosing your display configuration

Matrox Corona can be used as the VGA for your system. If you
want to use Matrox Corona as your VGA for single screen or
multi-head display mode, set DIP SW1 position 2 to off. Any
VGAs that are not being used in these modes should be
disabled. If you have a built-in VGA on your motherboard and
it is active, your system's BIOS will automatically disable it
when Matrox Corona has its DIP SW1 position 2 set to off.
SW1: DIP switch settings
)ÃPssÃÃ2Ã7DPTÃ…‚‡rp‡rqÃqrshˆy‡
ÃÃÃÃPÃ2Ã7DPTȁƒ…‚‡rp‡rq
!)ÃPssÃÃ2ÃHh‡…‚‘Ã8‚…‚h†
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃWB6ÃrhiyrqÃ
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÆvtyrÆp…rrÃ‚…Ã
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÀˆy‡vurhqÀ‚qr
ÃÃÃÃPÃÃ2ÃHh‡…‚‘Ã8‚…‚h†
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃWB6Ãqv†hiyrqÃ
ÃÃÃÃÃÃÃÃÃÃÃÃÃÃÃqˆhyÆp…rrÃ€‚qr
To use Matrox Corona in dual-screen mode, disable Matrox
Corona's VGA by setting DIP SW1 position 2 to on.
qrshˆy‡