Camera Power Supply Selection - Matrox Corona Installation And Hardware Reference

For customers planning to build their own cable, parts can be
purchased from:
Manufacturer:
Connector:
Manufacturer:
Shell:

Camera power supply selection

The camera power supply selection pins allow you to select the
voltage that is output from the Matrox Corona board through
the video input connector. As shown in the table below, place
the jumper across pins 1 and 2 for a +5 V supply output and
across pins 2 and 3 for a +12 V supply output.
Pin Voltage
1-2 +5 V
2-3 +12 V
This diagram shows the location of the camera supply selection
pins and the corresponding numbers. The default setting for
the jumper is +5 V.
Board input and output connectors
AMP
3-175677-0
AMP
1-176793-0
85