Operation; Helipath Quick Action Stand Setup; Helipath Setup; Power Up - Ametek BROOKFIELD HPQA Series Operation Instructions Manual

3. OPERATION

3.1 Helipath Quick Action Stand Setup

3.1.1 Helipath Setup

• Assemble the HPQA Laboratory Stand (refer to assembly instructions in Appendix A
of this manual)
• Insert the viscometer mounting handle into the lab stand clamp and tighten
Do not tighten the knob without a viscometer installed; damage may occur

3.1.2 Power Up

• Connect the power cord to the provided power supply. Plug the power cord into an A/C outlet
and the barrel connector into the rear of the HPQA. Do not provide power to any other
port; only the barrel port should supply power
• Route power cables for the both the viscometer/rheometer and the Helipath through the
cable management clips located on the back of the Helipath. Ensure all cables are clear
of moving parts and have enough slack to allow the full range of travel of the Helipath
Quick Action Stand
M-HPQA-001 H E L I PAT H Q U I C K A C T I O N L A B O R AT O R Y S TA N D - O P E R AT I O N A L M A N U A L
Power cables
17