Safety Instructions; Personnel; General; Operation And Maintenance - Ametek mocon Dansensor LeakPointer H2O User Manual

Dansensor LeakPointer H
®

Safety Instructions

Personnel

Personnel operating the device must be familiar with all aspects of its operation.

Personnel maintaining the machine must be proficient in its maintenance.

Personnel operating or maintaining the machine must not have hair, cloth or other things

hanging loosely on them. This can get tangled in the machine.
Such personnel should review the following precautions to promote safety awareness.

The machine should only be operated and maintained by personnel of normal height

(150 to 210 cm) and sound of mind and body.

General

Always refer to the manual before operating or maintaining the equipment.

Observe all WARNINGS, CAUTIONS and NOTES.

In case of technical problems please contact your service provider.

Do not expose the equipment to heavy moisture or heat and keep it away from direct

sunlight.
Never remove safety devices. This may only be done by authorised personnel during

service. This concerns the following parts:
- Silencer on the vacuum release valve.
The device must be installed by authorised personnel.

The device should only be installed inside a factory or test environment.

Never install the equipment in explosive environments.

Always use correct fittings and hoses when connecting the air pressure.

Provide adequate space around the equipment for operators to walk around the unit.

It is the responsibility of the owner and operator(s) of the equipment, that the installation is

made in accordance with local rules and regulations.
The manufacturer cannot be held responsible for any damage caused by incorrect

installation and maintenance of this equipment.

Operation and maintenance

CAUTION! At any sign of damage to the water chamber (tub or lid), they must be
replaced immediately! Inspect water chamber (tub and lid) daily!
Be sure to turn of air supply before performing any cleaning or maintenance

When operating or maintaining the equipment always obey the relevant rules and

regulations for workers safety.
Trained service personal only are allowed perform service and tune the machine.

Replace damaged chambers and lids immediately.

Replace damaged gas springs immediately.

Replace damaged hoses immediately.

Never block gas outlets.

No one shall replace parts or redesign anything on the device without permission from

MOCON Europe A/S.
O EN
2
User Guide 7
P/N 390225-C
11/2021