Table of Contents
Advertisement
SERVICING YOUR OUTBOARD MOTOR
PROPELLER REPLACEMENT
Before replacing the propeller,
remove the emergency stop
switch clip from the emergency
stop switch to prevent any
possibility of the engine being
started while you are working
with the propeller.
The propeller blades may have
sharp edges, so wear heavy
gloves to protect your hands.
Operating the outboard motor at
higher altitudes will reduce
available power. This may require
decreasing the propeller pitch to
maintain correct engine RPM.
112
ANTIVENTILATION PLATE
A BLOCK
OR PIECE
OF WOOD
PROPELLER
PROPELLER
When replacing the propeller, put
a suitable block or piece of wood
between the propeller and the
antiventilation plate to prevent
the propeller from rotating.
Removal
1. Remove the cotter pin,
unscrew the castle nut,
remove the washer, and then
remove the propeller and
thrust washer.
2. Inspect the propeller shaft for
any fishing line or debris.
Installation
Some propeller brands require
specific mounting hardware.
Refer to your specific propeller
manufacturer's instructions for
proper installation.
1. Apply marine grade grease to
the propeller shaft.
Advertisement
Table of Contents
