Trolling Mode - HONDA marine BF350A Owner's Manual

You can finely adjust the trim
angle manually while in trim
support mode.
In the case of a single outboard
motor, if you press the power
trim/tilt switch of the remote
control while in trim support
mode, you can fine-tune the trim
angle.
In the case of multiple outboard
motors, if you press the power
trim/tilt switch of the remote
control in the trim support mode,
you can fine-tune the trim angles
of all the outboard motors
simultaneously.
The finely adjusted angle is
temporarily overwritten with the
preset pattern, and returns to the
pattern before overwriting when
the engine switch or power
switch is turned off.
If you use the cruise control
mode while in the trim support
mode, the trim support mode is
temporarily stopped.
The trim support mode is forcibly
canceled in the following cases.
Trim angle is adjusted beyond
●
the trim area by the power
trim/tilt switch
GPS error or disconnection
●
Engine malfunction
●
(overheating, low oil pressure,
etc.)
Trim operation abnormality
●
Accelerating or decelerating
●
so quickly as to put a load on
trim
OPERATION

TROLLING MODE

[-] SWITCH [+] SWITCH
(ELECTRICAL REMOTE CONTROL
BOX and FLUSH-MOUNT type)
[-] Switch: Reduce engine speed
[+] Switch: Increase engine speed
After the engine warms up, when
the gearshift/throttle control
lever is tilted from the NEUTRAL
position to the FORWARD or
REVERSE side by about 20° and
the [+] switch is pressed and
held, the mode changes to
trolling mode.
73