ANODE INSPECTTION
ANODE (stern bracket)
ANODE
ANODE (each side)
The anodes are located on each side of the gear
case, on the right cooling water intake port and on
the stern bracket. They are made of a sacrificial
material that helps to protect the outboard motor
from corrosion.
WATER SCREEN (LEFT)
SCREWS
NUTS
WATER SCREEN (RIGHT)
SERVICING YOUR OUTBOARD MOTOR
Replace the anodes when they have been reduced
to about one third their original size, or if they are
crumbling.
Water Screen Removal/Installation
1. Loosen the screws and remove the nuts.
2. Remove the water screen (right).
3. Remove the water screen (left).
If the water inlet is clogged with waterweed or
mud, remove it.
4. Install the nuts and water screen (right) to the
gear case by holding the nuts.
5. Install the screws and water screen (left).
6. Be careful not to drop the nuts as you tighten
the screws.
TIGHTENING TORQUE:
0.7 lbf·ft (1.0 N·m, 0.1 kgf·m)
111