Table of Contents
Advertisement
Replacement
HOSE CLIPS
FUEL HOSES
1. Remove the engine cover (P.91).
2. Remove the front striker guide cover (P.107).
3. Remove the relay.
4. Disconnect the 2-pin coupler (blue).
5. Remove the suspension strap from the fuel filter
with water separator bracket, then remove the
suspension strap from the fuel filter with water
separator.
6. Bind the two fuel tubes with the tube clips to
prevent fuel leakage, disconnect the fuel tubes.
WATER SEPARATOR
SUSPENSION STRAP
2 PIN COUPLER
(BLUE)
RELAY
SERVICING YOUR OUTBOARD MOTOR
FUEL FILTER
WATER SEPARATOR
CUP
7. Remove the three screws holding the fuel filter
with water separator, empty the water or
deposits from the inside of the cup.
8. Thoroughly clean the cup. If the fuel filter is
clogged, or has reached the end of its
replacement period, replace it with a new one.
9. Reassemble the fuel filter with water separator in
the reverse order of removal. Use a new O-ring.
TIGHTENING TORQUE:
2.5 lbf·ft (3.4 N·m, 0.35 kgf·m)
O-RING (Replace)
SCREWS
109
Advertisement
Table of Contents
