Ongoing Maintenance; Routine Maintenance - Xerox DocuColor 2060 Installation Planning Manual

Ongoing maintenance

Routine maintenance

Installation Planning Guide
After the installation of your Xerox DocuColor 2060 NPS, there
are a few ongoing tasks that must be performed. These tasks
may include the following:
• Maintaining an adequate inventory of consumable supplies
• Overseeing routine maintenance and meter reporting
• Arranging for additional operator training
• Ordering additional fonts
• Ordering additional documentation
• Placing service calls for hardware problems
• Obtaining assistance in solving software-related problems.
As installation coordinator, it is your responsibility to designate
the staff members responsible for these tasks.
A number of routine maintenance tasks must be performed to
ensure maximum efficiency of your printer. These tasks include:
• Adding standard dry ink to your printer
• Adding colored dry ink to your printer
• Adding fuser lubricant
• Replacing the dry ink and developer waste containers
• Cleaning the exterior surfaces of the system.
Step-by-step instructions for performing these tasks are
contained in your Guide to Performing Routine Maintenance . You
need to decide how many operators will be responsible for
performing these tasks. Most maintenance tasks are covered in
the initial operator training provided shortly after installation.
NOTE: Only operators who have completed the Xerox
Advanced Customer Training (ACT) or eXcellerate courses or
equivalent advanced customer training can replace stitcher wire.
Refer to the "Xerox support services" appendix of this guide for
additional information on training.
Installation
8-5