Xerox DocuColor 2060 Installation Planning Manual page 169

Table F-3. JES3 FSS statement parameters (Continued)
Item
description Default
COPYMARK J
DGROUP None
DTYPE None
DYNAMIC NO
FSSNAME None
JNAME None
JUNIT ON
MODE None
Installation Planning Guide
Defining the printer to the host: TCP/IP attachment
Range of
Source of acceptable
value values
Installation N or J or C
preferences
Installation 1 to 8-character
printer alphanumeric
destination string
naming
conventions
PRTAFP1 PRTAFP1
Installation YES or NO
printer name
standards
Name of FSA 1 to 8-character
in JNAME alphanumeric
parameter string
FSSNAME 1 to 8-character
parameter of alphanumeric
FSSDEF string
statement
See (Device address,
comments. Main, dest class,
ON/OFF)
Must be FSS. FSS
Comments
C: printer will offset-
stack or stitch on a
dataset copy basis.
J: Printer is to
increment offset
stacking or stitching on
a job boundary.
N: Copymarks are
constant, and no offset
stacking or stitching is
done.
Specifies destination
processed by this FSA
(applicable only if D is
specified in the WS
parameter).
Required parameter
DYNAMIC=NO should
be specified so JES3
will keep FSA active
between transmission
of datasets.
Must match value in
FSSNAME parameter
of FSSDEF statement.
Must match value in
FSSNAME parameter
of FSSDEF statement.
Device address should
not be specified for
TCP/IP printers.
Main is name of
processor the FSS is to
run on.
Dest class is
destination class for
FSA messages.
ON or OFF specifies
whether FSA is initially
online or offline.
MODE=FSS must be
specified.
Your
value
F-7