Supporting Docucolor 2060 Nps/Ips On The File Server - Xerox DocuColor 2060 Installation Planning Manual

Supporting DocuColor 2060 NPS/IPS on the file server

Installation Planning Guide
DocuColor 2060 NPS/IPS on a Novell network
• Provide all of the required installation parameters identified in
the checklist provided in Chapter 2 of this guide to your
service representative.
In the following illustration, the queue, remote printer, and virtual
printer are configured with the same name, and the specified
printer is set to print duplex. The user sends a print job through
the LPT1 port to a queue named DPDuplex that is sent to the
DPDuplex, and assigned to DPDuplex virtual printer.
Client Netware
Workstation File Server
Queue
Device
LPT1 Gazette
Figure D-4. DocuColor 2060 NPS/IPS configured as an
RPRINTER
There are a number of tasks you perform on the file server to
support the DocuColor 2060 NPS/IPS as either a print server or
a remote printer:
• With DocuColor 2060 NPS/IPS as a PSERVER you must
allow unencrypted password login on the file server. Enter the
following command at the file server console prompt and in
the AUTOEXEC.NCF file:
set allow unencrypted passwords=on
NOTE: Set this command even if you do not establish a print
server password. Novell clients that use encrypted
passwords are unaffected by this change and will continue to
use encrypted passwords.
• Do not configure the file server to support IPX checksums or
NCP packet signatures. Set these options to equal 0 or 1 so
that the server performs these options only when the client
requests them. The default value is 1.
• Do not set the watchdog interval to less than one minute.
Longer intervals may cause the DocuColor 2060 NPS/IPS to
be logged out.
Netware File Server
RPRINTER configuration
Remote
Printer
Gazette
DocuPrint
Virtual
Printer
Gazette
D-13