Xerox DocuColor 2060 Installation Planning Manual page 167

Table F-1. JES2 FSS statement parameters (Continued)
Item
description Default
ROUTECDE None
START YES
TRKCELL no
WS None
FSS (FSS1)
PRT0001
Configuring in
JES3
Installation Planning Guide
Defining the printer to the host: TCP/IP attachment
Range of
Source of acceptable
value values
Installation 1 to 4
printer name destination
standards names
Should be NO YES or NO
for TCP/IP
printers.
See JES2 YES or NO
SPOOLDEF
statement
Installation See JES2
preferences Initialization
and Tuning
Manual.
Following is an example of the JES2 Initialization Dataset
required commands:
Table F-2. JES2 Initialization Dataset commands example
PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES
CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,
START=NO,TRKCELL=YES,WS=(Q)
Follow these steps to configure the PSF printer in JES3:
1. Locate the JES3 initialization dataset (commonly known as
Initialization Deck) in the JES3 catalogued JCL Procedure.
(This is normally kept in SYS1.PROCLIB, although your
system may use a different library.)
The JES3 PROC has a JES3IN DD statement, which points
to the initialization dataset. The default initialization deck is in
SYS1.SAMPLIB (member JES3IN00); however, you should
verify your location by looking at the JES3 procedure.
2. Enter the following required commands in the JES3
initialization deck to define the PSF functional subsystem
(FSS):
• One FSSDEF statement for each PSF functional
subsystem
Comments
If WS if F, only output
with these destinations
is selected for this
printer.
START=NO should be
specified so TCP/IP
can be started before
the FSS.
IBM recommends
YES.
Consider CL, R, and F.
See JES2 Initialization
and Tuning Manual for
more information.
Your
value
F-5