Xerox DocuColor 2060 Installation Planning Manual page 168

Defining the printer to the host: TCP/IP attachment
Item
description Default
FSSDEF parameters
FSSNAME None
MSGDEST JES
PNAME None
SYSTEM Same as
specified in
JUNIT
parameter
of DEVICE
statement
TERM NO
TYPE
DEVICE parameters
BURST YES
F-6
• One DEVICE statement for each functional subsystem
application (FSA) under control of the FSS.
The following table lists the JES3 FSS statement parameters
to be defined.
Table F-3. JES3 FSS statement parameters
Range of
Source of acceptable
value values
Installation 1 to 8-character
preferences alphanumeric
string
Installation JES or a
preferences destination class
name
Name of the 1 to 8-character
FSS alphanumeric
procedure string
System ID of Valid system ID
system the name
FSS is to run
on.
Installation YES or NO
preferences
TYPE=WTR WTR
must be
specified
Installation YES or NO
preferences ,M
Comments
Specifies name of the
FSS. (Required
parameter)
Specifies the console
destination class for
FSS messages.
Specifies the
procedure for starting
this FSS. (Different
FSSDEF statements
may refer to same
procedure.)
Can also be specified
as QUEUE=
YES specifies FSS
terminates if JES3
global address space
is terminated.
Specifies FSS is an
output writer.
TYPE=WTR must be
specified.
,M specifies
MARKFORM, which
causes printer to
offset-stack or stitch
jobs, subject to
printer's setting and the
COPYMARK
parameter.
Installation Planning Guide
Your
value