Xerox DocuColor 2060 Installation Planning Manual page 119

Duplexing
Characteristics
Special stocks
Installation Planning Guide
The DocuColor 2060 NPS/IPS prints duplex from all paper trays
up to 220 gsm.
The system does not print duplex on media heavier than 220
gsm or larger than 12.6 x 18" / 321.1 x 458.1 mm.
The paper stock should have the following characteristics:
• Low moisture content (a paper-to-moisture ratio below 5.7
percent). Paper with higher moisture content may curl and
jam.
• Smooth surface
• Moisture-resistant wrapping
• No defects (bent edges, uneven surfaces)
• Grain long (parallel with the long side of paper).
Paper is usually fed into the printer with the long side as the
leading edge. When you purchase paper, buy long-grain
paper. Make sure the grain is parallel with the long side (long-
grain) for the most reliable feeding and stacking.
Following are some guidelines for choosing and using special
materials. Refer to table 1 to determine if the tray used is capable
of handling the special stock.
• Transparencies: Use only the transparencies
recommended: Xerox Removable Paper Stripe: USA and
Canada, 3R5765; Xerox Europe, 3R93179.
Load transparencies into tray 3 with the paper stripe side
facing DOWN and with the stripe as the leading edge. (The
leading edge is the edge that feeds into the printer first.)
• Labels: Must be the type designed for high-speed printers
and must meet the specifications described in the section
above. Loading instructions are printed on all paper trays.
Load labels with the label side up. You can direct them to any
output tray.
• Tinted paper: Available in a variety of colors, it has many
uses, including calling attention to certain printed material,
separating special sections, or dividing chapters of a report.
• Preprinted paper: May be letterhead, forms, or logos.
Supplies
A-3